Migrate the Validator
You might need to migrate your validator to a new server for reasons such as hardware failure or upgrading to better hardware. This guide will show you how to do this safely and avoid the risk of double signing.
Sync the new node
The first crucial step is to set up and fully synchronize your new node on the new server. To verify the sync status of your node, simply click here
Stop the old node
Once your new full node is fully synchronized, you can shut down the old node by running the following command:
sudo systemctl stop cosmovisor.service
Next, remove the firewall rule for port 26659 with this command:
sudo ufw delete allow 26659
Update TMKMS Config
To update the TMKMS configuration on your VPS, follow these steps:
sudo nano tmkms/config/tmkms.toml
Locate the [[validator]] block in the file and update the following line with the new node's IP address:
addr = "tcp://<new_node_ip>:26659"
Update the new node config
Open the config.toml file on your new node:
sudo nano .sentinelhub/config/config.toml
Find the line for priv_validator_addr and update it with the following:
priv_validator_laddr = "tcp://0.0.0.0:26659"
Ensure the firewall on your new node allows traffic on port 26659 exclusively from the TMKMS machine. Use the following command:
sudo ufw allow from <tmkms_ip> to <new_node_ip> port 26659
Replace <tmkms_ip> with the IP address of your TMKMS machine and <new_node_ip> with the IP address of your new node.
Restart Services
Once you've updated both the config.toml and tmkms.toml files, restart the services in the following order:
TMKMS
On your TMKMS machine and run:
sudo systemctl restart tmkms.service
New Node
On your new Node and type:
sudo systemctl restart cosmovisor.service
After completing these steps, the priv_validator_key.json on TMKMS will be securely connected to your new full node, allowing it to operate as a Validator and resume signing blocks.